This was one of our larger non-powered projects in Southeast Asia, and the design brief was simple: keep families on site for three hours without a single motor.
The park combined a slide complex with climbing and swing structures, arranged so guests move through the site rather than queue at one attraction.
المواصفات الرئيسية
| غرض | مرجع |
|---|---|
| دولة | Malaysia |
| نوع المشروع | Non-powered family park |
| Contract value | دولار أمريكي 125,900 class project |
| نِطَاق | توريد المعدات, إرشادات الشحن والتركيب |
| مزج | مجمع الشرائح, التسلق, swing and family play |
| يدعم | تصميم التخطيط, surfacing notes and staff training |
جميع الأرقام هي قيم مرجعية وتم تأكيدها في الاقتراح الهندسي لموقعك.
Zoning a Large Play Area
The plot was divided into a main play zone, a toddler area and a shaded family zone with seating and service points. The slide complex sat where it is visible from the entrance, while older childrens climbing equipment was placed furthest from the toddler area to keep supervision simple and reduce collisions.
Equipment Selected for Tropical Use
Structures were specified for heat, الرطوبة والأمطار الغزيرة: protected steel frames, UV stable finishes and netting that keeps its strength when wet. Impact surfacing was chosen to drain rather than hold water, and fall heights were recorded on the layout so the park can check depths on a schedule.
Installation and Handover
The equipment shipped in phases so the park could open its main zone first and complete the secondary areas afterwards. Installation ran under factory supervision with local labour, followed by commissioning checks and staff training on daily inspection, supervision positions and capacity control.
Running a Non-Powered Park Profitably
Without machines, the operating cost is staffing, cleaning and surfacing maintenance – which is why the park carries a small team and keeps entry pricing simple. The same logic is described in our guide to a non powered amusement park, and the safety approach follows recognised playground practice such as في 1176.
صُنع ليناسب حديقتك
كل ما هو مرئي هو لك لتحديد: تخطيط المنطقة, مزيج المعدات, السطح والظل.
كل وحدة تترك أ 125,000 مصنع متر مربع في الصين مع سجلات الاختبار, الرسومات وقائمة قطع الغيار الموصى بها, وهو ما أ شريك التصنيع ينبغي تسليمها بدلا من مجرد الفاتورة. يتم شحن الهياكل غير المزودة بالطاقة ببيانات ارتفاع السقوط وتوصيات السطح لكل منصة ومخرج شريحة.
شارك تخطيط الموقع وسنقوم بإعداد مخطط منطقة يوضح الهياكل, تسطيح, الصرف وتسلسل البناء فيها.
