This project paired a slide combination with three smaller non-powered units – a practical mix when the budget goes further by combining attractions rather than buying one large structure.
The slide combination anchors the zone, and the smaller units give younger children their own options so the main slides are not overloaded.
المواصفات الرئيسية
| غرض | مرجع |
|---|---|
| دولة | فيلبيني |
| نوع المشروع | Slide combination with play equipment |
| Contract value | دولار أمريكي 55,986 class project |
| نِطَاق | Equipment supply and installation guidance |
| مزج | Slide combination plus three play units |
| يستخدم | Outdoor family playground |
جميع الأرقام هي قيم مرجعية وتم تأكيدها في الاقتراح الهندسي لموقعك. Operators planning a similar project usually start from our fibreglass slide.
Lane Layout and Run Out
Lane count and chute profiles were chosen for family use, with enough run out that guests come to a stop before the landing zone edge. Side walls and entry handrails were specified for wet conditions, and the landing area was kept separate from the main circulation so waiting guests never cross a slide exit.
Balancing the Mix
The three play units were chosen for different ages and abilities: one for toddlers, one climbing and balancing element, and one for group play. Spreading interest across four installations raises the number of children the zone holds and reduces the queue pressure that appears when one attraction carries the whole park.
Installation and Site Preparation
Concrete pads and surfacing levels were completed before the container arrived, so installation ran inside the planned window with no site delays. Chutes are moulded composite and frames are protected steel, so the handover focused on joint checks, side wall fixings and the surfacing survey.
Maintenance for a Slide Led Zone
Daily checks cover chute surfaces, handrails and landing areas; weekly work covers joint bolts, frame fixings and netting where fitted. Damaged gel coat is repaired before water reaches the laminate, which is the single most important habit for fibreglass slides in a wet climate.
صُنع ليناسب حديقتك
عليك أن تقرر المظهر, نحن نحافظ على المعايير الهندسية: عدد الممرات, chute profiles, colours and play unit selection.
ال الشركة المصنعة هنا المصنع نفسه: تصميم, أعمال الصلب, صب, يحدث التجميع والاختبار داخل ملف 125,000 قاعدة إنتاج متر مربع, ويتم تشغيل كل وحدة تحت الحمل قبل تعبئتها. يتم شحن الهياكل غير المزودة بالطاقة ببيانات ارتفاع السقوط وتوصيات السطح لكل منصة ومخرج شريحة.
أرسل خطة قطعة الأرض الخاصة بك وتفضيلات السطح – سوف نعيد تخطيطًا بارتفاعات السقوط, استراتيجية الظل وقائمة المعدات المرحلية.
