필리핀 슬라이드 조합 프로젝트

This project paired a slide combination with three smaller non-powered units – a practical mix when the budget goes further by combining attractions rather than buying one large structure.

The slide combination anchors the zone, and the smaller units give younger children their own options so the main slides are not overloaded.

모든 수치는 참조 값이며 귀하의 현장에 대한 엔지니어링 제안에서 확인되었습니다.. Operators planning a similar project usually start from our fibreglass slide.

Lane count and chute profiles were chosen for family use, with enough run out that guests come to a stop before the landing zone edge. Side walls and entry handrails were specified for wet conditions, and the landing area was kept separate from the main circulation so waiting guests never cross a slide exit.

The three play units were chosen for different ages and abilities: one for toddlers, one climbing and balancing element, and one for group play. Spreading interest across four installations raises the number of children the zone holds and reduces the queue pressure that appears when one attraction carries the whole park.

Concrete pads and surfacing levels were completed before the container arrived, so installation ran inside the planned window with no site delays. Chutes are moulded composite and frames are protected steel, so the handover focused on joint checks, side wall fixings and the surfacing survey.

Daily checks cover chute surfaces, handrails and landing areas; weekly work covers joint bolts, frame fixings and netting where fitted. Damaged gel coat is repaired before water reaches the laminate, which is the single most important habit for fibreglass slides in a wet climate.

외모는 네가 결정해, 우리는 엔지니어링 표준을 유지합니다: 차선 수, chute profiles, colours and play unit selection.

그만큼 제조업체 여기 공장 자체가 있어요: 설계, 가얼 구조, 조형, 조립과 테스트는 모두 내부에서 이루어집니다. 125,000 평방미터 생산기지, 모든 장치는 포장되기 전에 부하가 걸린 상태에서 실행됩니다.. 무동력 구조물에는 모든 플랫폼 및 슬라이드 출구에 대한 추락 높이 데이터 및 표면 권장 사항이 함께 제공됩니다..

플롯 계획 및 표면 선호 사항 보내기 – 낙하 높이가 포함된 레이아웃을 반환하겠습니다., 셰이드 전략 및 단계별 장비 목록.