This project paired a slide combination with three smaller non-powered units – a practical mix when the budget goes further by combining attractions rather than buying one large structure.
The slide combination anchors the zone, and the smaller units give younger children their own options so the main slides are not overloaded.
Kluczowe dane techniczne
| Przedmiot | Odniesienie |
|---|---|
| Kraj | Filipiny |
| Typ projektu | Slide combination with play equipment |
| Contract value | USD 55,986 class project |
| Zakres | Equipment supply and installation guidance |
| Mieszać | Slide combination plus three play units |
| Używać | Outdoor family playground |
Wszystkie liczby są wartościami referencyjnymi i zostały potwierdzone w projekcie technicznym dla Twojej lokalizacji. Operators planning a similar project usually start from our fibreglass slide.
Lane Layout and Run Out
Lane count and chute profiles were chosen for family use, with enough run out that guests come to a stop before the landing zone edge. Side walls and entry handrails were specified for wet conditions, and the landing area was kept separate from the main circulation so waiting guests never cross a slide exit.
Balancing the Mix
The three play units were chosen for different ages and abilities: one for toddlers, one climbing and balancing element, and one for group play. Spreading interest across four installations raises the number of children the zone holds and reduces the queue pressure that appears when one attraction carries the whole park.
Installation and Site Preparation
Concrete pads and surfacing levels were completed before the container arrived, so installation ran inside the planned window with no site delays. Chutes are moulded composite and frames are protected steel, so the handover focused on joint checks, side wall fixings and the surfacing survey.
Maintenance for a Slide Led Zone
Daily checks cover chute surfaces, handrails and landing areas; weekly work covers joint bolts, frame fixings and netting where fitted. Damaged gel coat is repaired before water reaches the laminate, which is the single most important habit for fibreglass slides in a wet climate.
Dopasowane do Twojego parku
Ty decydujesz o wyglądzie, utrzymujemy standard inżynieryjny: Liczba pasów, chute profiles, colours and play unit selection.
The producent oto sama fabryka: projekt, konstrukcje stalowe, odlewanie, montaż i testowanie odbywają się wewnątrz a 125,000 baza produkcyjna o powierzchni metra kwadratowego, a każda jednostka przed zapakowaniem jest uruchamiana pod obciążeniem. Konstrukcje niezasilane są dostarczane z danymi dotyczącymi wysokości upadku i zaleceniami dotyczącymi nawierzchni dla każdej platformy i wyjścia ze zjeżdżalni.
Wyślij plan działki i preferencje dotyczące nawierzchni – zwrócimy układ z wysokościami upadku, strategia cieniowania i etapowa lista wyposażenia.
