This project paired a slide combination with three smaller non-powered units – a practical mix when the budget goes further by combining attractions rather than buying one large structure.
The slide combination anchors the zone, and the smaller units give younger children their own options so the main slides are not overloaded.
主な仕様
| アイテム | 参照 |
|---|---|
| 国 | Philippines |
| プロジェクトの種類 | Slide combination with play equipment |
| Contract value | 米ドル 55,986 class project |
| 範囲 | Equipment supply and installation guidance |
| ミックス | Slide combination plus three play units |
| 使用 | Outdoor family playground |
すべての数値は参考値であり、お客様のサイトのエンジニアリング提案で確認されます。. Operators planning a similar project usually start from our fibreglass slide.
Lane Layout and Run Out
Lane count and chute profiles were chosen for family use, with enough run out that guests come to a stop before the landing zone edge. Side walls and entry handrails were specified for wet conditions, and the landing area was kept separate from the main circulation so waiting guests never cross a slide exit.
Balancing the Mix
The three play units were chosen for different ages and abilities: one for toddlers, one climbing and balancing element, and one for group play. Spreading interest across four installations raises the number of children the zone holds and reduces the queue pressure that appears when one attraction carries the whole park.
Installation and Site Preparation
Concrete pads and surfacing levels were completed before the container arrived, so installation ran inside the planned window with no site delays. Chutes are moulded composite and frames are protected steel, so the handover focused on joint checks, side wall fixings and the surfacing survey.
Maintenance for a Slide Led Zone
Daily checks cover chute surfaces, handrails and landing areas; weekly work covers joint bolts, frame fixings and netting where fitted. Damaged gel coat is repaired before water reaches the laminate, which is the single most important habit for fibreglass slides in a wet climate.
あなたの公園に合わせて作られています
見た目を決めるのはあなたです, 私たちはエンジニアリング標準を維持します: 車線数, chute profiles, colours and play unit selection.
の メーカー ここが工場そのものです: デザイン, 製鉄所, 成形, アセンブリとテストはすべて内部で行われます 125,000 平方メートルの生産拠点, すべてのユニットは梱包される前に負荷がかかって実行されます. 非動力構造物には、すべてのプラットフォームとスライド出口の落下高さデータと浮上に関する推奨事項が付属しています。.
区画プランと表面の好みを送信してください – 落下高さを含むレイアウトを返します, シェード戦略と段階的な装備リスト.
