This project paired a slide combination with three smaller non-powered units – a practical mix when the budget goes further by combining attractions rather than buying one large structure.
The slide combination anchors the zone, and the smaller units give younger children their own options so the main slides are not overloaded.
Ključne specifikacije
| Postavka | Referenca |
|---|---|
| Država | Filipini |
| Vrsta projekta | Slide combination with play equipment |
| Contract value | USD 55,986 class project |
| Področje uporabe | Equipment supply and installation guidance |
| Zmešajte | Slide combination plus three play units |
| Uporaba | Outdoor family playground |
Vse številke so referenčne vrednosti in so potrjene v inženirskem predlogu za vašo lokacijo. Operators planning a similar project usually start from our fibreglass slide.
Lane Layout and Run Out
Lane count and chute profiles were chosen for family use, with enough run out that guests come to a stop before the landing zone edge. Side walls and entry handrails were specified for wet conditions, and the landing area was kept separate from the main circulation so waiting guests never cross a slide exit.
Balancing the Mix
The three play units were chosen for different ages and abilities: one for toddlers, one climbing and balancing element, and one for group play. Spreading interest across four installations raises the number of children the zone holds and reduces the queue pressure that appears when one attraction carries the whole park.
Installation and Site Preparation
Concrete pads and surfacing levels were completed before the container arrived, so installation ran inside the planned window with no site delays. Chutes are moulded composite and frames are protected steel, so the handover focused on joint checks, side wall fixings and the surfacing survey.
Maintenance for a Slide Led Zone
Daily checks cover chute surfaces, handrails and landing areas; weekly work covers joint bolts, frame fixings and netting where fitted. Damaged gel coat is repaired before water reaches the laminate, which is the single most important habit for fibreglass slides in a wet climate.
Narejeno za vaš park
Vi se odločite za videz, ohranjamo inženirski standard: Število pasov, chute profiles, colours and play unit selection.
The proizvajalec tukaj je sama tovarna: oblikovanje, jeklarska konstrukcija, oblikovanje, montaža in testiranje potekata znotraj a 125,000 kvadratni meter proizvodne baze, in vsaka enota teče pod obremenitvijo, preden se zapakira. Strukture brez pogona so dobavljene s podatki o višini padca in priporočili glede površine za vsako ploščad in drsni izhod.
Pošljite svoj načrt parcele in želeno površino – vrnili bomo postavitev z višinami padca, strategijo senčenja in seznam opreme po fazah.
